Building Science Series, Issues 21-35 |
From inside the book
Results 1-5 of 100
Page 6
... observed during tests of bathtubs man factured from the materials designated . The o served deflections for individual units tested a pear in table 2.2-1 . Table 2.2-1 also includes t results of tests performed on units using a 3 - i ...
... observed during tests of bathtubs man factured from the materials designated . The o served deflections for individual units tested a pear in table 2.2-1 . Table 2.2-1 also includes t results of tests performed on units using a 3 - i ...
Page 10
... observed after an 1 in drop . It should be noted that damage was o served only for the steel tubs . As the tubs we tested in height - of - drop increments of 6 in , it not known if the observed damage would ha occurred had the weight ...
... observed after an 1 in drop . It should be noted that damage was o served only for the steel tubs . As the tubs we tested in height - of - drop increments of 6 in , it not known if the observed damage would ha occurred had the weight ...
Page 11
... observed at 12 in . 3. The use of successive heights - of - drop ( 5- , 10- , and 15 - in ) in the recommended test is believed to be desirable since there is a lack of information on Time 24-1 . Revilts of concentrated dynamic load ...
... observed at 12 in . 3. The use of successive heights - of - drop ( 5- , 10- , and 15 - in ) in the recommended test is believed to be desirable since there is a lack of information on Time 24-1 . Revilts of concentrated dynamic load ...
Page 12
... observe initial defle tion reading on the dial gage . 2. Apply test load and observe the deflectio reading . 3. Inspect the tested surface in accordance wit section 2.8 , following removal of load . Take speci care to determine if ...
... observe initial defle tion reading on the dial gage . 2. Apply test load and observe the deflectio reading . 3. Inspect the tested surface in accordance wit section 2.8 , following removal of load . Take speci care to determine if ...
Page 13
... observed when a 10 - lb load , as prescribed in CS 221-59 , was imposed on the sidewalls . The maximum observed deflection on any specimen was slightly less than half that permitted by the Commercial Standard . 352-020 070- -3 TABLE 2.5 ...
... observed when a 10 - lb load , as prescribed in CS 221-59 , was imposed on the sidewalls . The maximum observed deflection on any specimen was slightly less than half that permitted by the Commercial Standard . 352-020 070- -3 TABLE 2.5 ...
Other editions - View all
Common terms and phrases
applied asphalt ASTM axial load bathtub block brick Building Science Series Bureau of Standards cents Chromel coating color retention Column loads components compressive strength computed construction coordination cracking deg F developed dimensional Dolomite eccentricity effect enamels exposure failure fixture flexural floor load versus Fly Ash FRPE gloss high-bond horizontal industry Kure Beach load versus beam load versus translation louver Major floor load masonry materials maximum measured ment midspan mixer mixing device modular module mortar National Bureau Output Channel percent performance plumbing fixtures Porcelain Enamels Portland Cement precoordination Prestressed Concrete prestressing prisms resistance resistance thermometer shear shear strength shown in figure slab south wind load specifications specimens steel surface temperature tensile strength test results test structure thermistors thermocouples tion vane versus beam deflection VERTICAL DEFLECTION vertical load walls west wind load wind load versus
Popular passages
Page 127 - ABSTRACT (A 200-word or less factual summary of most significant information. If document includes a significant...
Page 6 - In no case does such identification imply recommendation or endorsement by the National Bureau of Standards , nor does it imply that the...
Page 11 - FOR COMPUTER SCIENCES AND TECHNOLOGY conducts research and provides technical services designed to aid Government agencies in improving cost effectiveness in the conduct of their programs through the selection, acquisition, and effective utilization of automatic data processing equipment; and serves as the principal focus...
Page 3 - This report gives findings and recommendations developed during an investigation of performance characteristics for sanitary plumbing fixtures, conducted at the request of the Building Research Advisory Board of the National Academy of Sciences-National Research Council. The...