Printed Circuit Boards: Design, Fabrication, and Assembly
McGraw Hill Professional, 2005 M09 7 - 704 pages
The printed circuit is the basic building block of the electronics hardware industry. This is a comprehensive single volume self-teaching guide to the art of printed circuit board design and fabrication -- covering the complete cycle of PCB creation, design, layout, fabrication, assembly, and testing.
Results 1-3 of 78
M Codes: M codes are used for machine control. The most commonly used codes
are: M00 — Full machine stop, commonly ignored by many plotters; M01 —
Temporary machine stop, commonly ignored by many plotters; and M02 — End
However, highly sophisticated drilling machines operate upto 1,00,000 rpm.
Hudson (2003) describes the development of multi-head drilling system with
vision which can operate at 275,000 rpm. The machine allows fully independent
The tip of the syringe is placed on the pad, the machine is activated with a hand
foot operation until each pad receives the requisite amount of solder paste on it.
Bare card Apply solder paste Place all components Reflow solder De-grease ...
What people are saying - Write a review
1 Basics of Printed Circuit Boards
2 Electronic Components
3 Layout Planning and Design
15 other sections not shown
Other editions - View all
Printed Circuit Boards: Design, Fabrication, Assembly and Testing
R. S. Khandpur
Limited preview - 2005
Printed Circuit Boards : Design, Fabrication, and Assembly: Design ...
No preview available - 2005