Printed Circuit Boards: Design, Fabrication, and Assembly
McGraw Hill Professional, 2005 M09 7 - 704 pages
The printed circuit is the basic building block of the electronics hardware industry. This is a comprehensive single volume self-teaching guide to the art of printed circuit board design and fabrication -- covering the complete cycle of PCB creation, design, layout, fabrication, assembly, and testing.
Results 1-3 of 83
Self-Adhesive Pads Pads are available in standard shapes such as donut,
square, hex, oval, and tear drop and triangular. These are shown in Figure 5.1b.
The two different types of pads which are commonly used are: Self-adhesive type
Tape and pads for the component side traces Use 5 to 7 mil thick polyester Tape
and pads for the non-component side traces Tape is on farside Pads Tape
Polyester film Tape Pads Polyester film (Registration is very important from pads
Ideally the legs of the device will slope down from the body by 1-2 degrees. This
will allow the legs to flatten on to the pads when the component is placed on to
the PCB. a A thin film of flux is lightly applied to the pads. a The component is
What people are saying - Write a review
1 Basics of Printed Circuit Boards
2 Electronic Components
3 Layout Planning and Design
15 other sections not shown
Other editions - View all
Printed Circuit Boards: Design, Fabrication, Assembly and Testing
R. S. Khandpur
Limited preview - 2005
Printed Circuit Boards : Design, Fabrication, and Assembly: Design ...
No preview available - 2005