Printed Circuit Boards: Design, Fabrication, and Assembly
McGraw Hill Professional, 2005 M09 7 - 704 pages
The printed circuit is the basic building block of the electronics hardware industry. This is a comprehensive single volume self-teaching guide to the art of printed circuit board design and fabrication -- covering the complete cycle of PCB creation, design, layout, fabrication, assembly, and testing.
Results 1-3 of 47
Resistors. The most commonly used component in an electronic assembly is the
resistor. It is a passive component which exhibits a controlled value of resistance
across its two leads. Resistance, by definition, is the opposition to the R Fixed ...
Figure 2.8 shows two arrangements for SIL packages. The resistance network is
made with many resistors of the same value. One side of each resistor is
connected with one side of all the other resistors inside. Eight resistors are
housed in the ...
2.2.3 Characteristics The main parameters that define a resistor are detailed
below. Resistance: This is the nominal value of resistance between the two leads
of the resistor when measured at 25°C. Tolerance: This is the maximum deviation
What people are saying - Write a review
1 Basics of Printed Circuit Boards
2 Electronic Components
3 Layout Planning and Design
15 other sections not shown
Other editions - View all
Printed Circuit Boards: Design, Fabrication, Assembly and Testing
R. S. Khandpur
Limited preview - 2005
Printed Circuit Boards : Design, Fabrication, and Assembly: Design ...
No preview available - 2005