Printed Circuit Boards: Design, Fabrication, and Assembly
McGraw Hill Professional, 2005 M09 7 - 704 pages
The printed circuit is the basic building block of the electronics hardware industry. This is a comprehensive single volume self-teaching guide to the art of printed circuit board design and fabrication -- covering the complete cycle of PCB creation, design, layout, fabrication, assembly, and testing.
Results 1-3 of 48
In addition to the optical inspection as well as monitoring the process parameters
during the soldering process, the complete evaluation of a solder joint involves
many other tests and procedures. Some of the commonly used tests are: ...
18.104.22.168 Minimum Side Joint Length The entire fillet for soldering should be
properly wetted along the full length of the lead. The joint is not at acceptable, if
the side joint lengthD is less than the lead width. The lead width is measured
from the ...
22.214.171.124 Wicking In the wicking process, a heated wick, well-saturated with rosin
, is placed on top of the joint to be de-soldered. The solder will flow rapidly into
the rosin area due to capillary action leaving the joint to which it was previously ...
What people are saying - Write a review
1 Basics of Printed Circuit Boards
2 Electronic Components
3 Layout Planning and Design
15 other sections not shown
Other editions - View all
Printed Circuit Boards: Design, Fabrication, Assembly and Testing
R. S. Khandpur
Limited preview - 2005
Printed Circuit Boards : Design, Fabrication, and Assembly: Design ...
No preview available - 2005